Runco PLASMAWALL XP-65DHDXA - Manual (Page 37)

PlasmaWall XP-65DHD Owner’s Operating Manual 27
PRE
L
IMINAR
Y
4.1
Turning on the Power 1. Turn on your source components.
2. Plug the female end of
the power cord into
the AC receptacle on
the rear of the
PlasmaWall. Connect
the other end to your
AC power source.
3. Similarly connect the DHD Controller to a nearby AC outlet.
4. Press the main power switch at the front of the PlasmaWall (see Figure 2-1). The
standby/on indicator lights green.
5. Set the main power switch at the rear of the DHD Controller (see Figure 2-4) to the “on”
position.
6. Press the ON button on the remote control to
turn on the DHD Controller and PlasmaWall (or
press the power button on the front of the DHD
Controller). The power indicator on the DHD
Controller lights solid blue.
7. After a brief warm-up period (approximately 10
seconds), the PlasmaWall will display an image.
4. Operation