Ryobi 130rEB - Manual (Page 8)

ASSEMBLY INSTRUCTIONS
8
Fig. 3
Fig. 4
INSTALLING CUTTING ATTACHMENT SHIELD
WARNING: To avoid injury, never operate the
trimmer without the cutting attachment shield
installed. If the trimmer is operated without it
in place, you will VOID the warranty.
1. Place the cutting attachment shield onto the shaft
housing above the clamp assembly (Fig. 3).
2. Push the cutting attachment shield down to the top
of the cutting attachment assembly and then rotate
the cutting attachment shield 180°. Align the 4 screw
holes and fit the cutting attachment shield securely
in the recessed pocket (Fig. 3).
3. Install the four (4) screws (10-24 x 1/2) with a regular
Phillips screwdriver (Fig. 4). Tighten securely.
Screws
Cutting
Attachment
Shield
Cutting
Attachment
Clamp
Assembly
Shaft Housing
Fig. 1
Fig. 2
D Handle
Wing Nut
ADJUSTING THE D-HANDLE
1. Hold the unit in the operating position (Fig. 1).
2. Loosen the wing nut (Fig. 2). It is not necessary to
remove the wing nut, washer or bolt.
3. Position the D-handle to the location that provides
you the best grip, and tighten the wing nut (Fig. 2).