Runco PL-50XA User Manual

Page 31

Table of Signals Supported

Model

[ Signal Type ]

Dots x Lines

Vertical

Freq.

(Hz)

Horizontal

Freq.

(kHz)

Sync Polarity

Presence

Screen Mode

RGB

Select

DVI

Mem-

ory

Horizontal

Vertical

Horizontal

Vertical

Normal

(4:3)

Full

(16:9)

Work Station

(Sun)

1024 X 768

60.0

49.7

YES

1280 X 1024

60.0

63.9

YES

IDC-3000G

PAL625P

768 X 576

50.0

31.4

NEG

YES

NTSC525P

640 X 480

59.9

31.5

NEG

YES

MOTION

*1 Only when using a graphic accelerator board that is capable of displaying 1365 X 768.

*2 Display only 400 lines with the screen center of the vertical orientation located at the center.

*3 The picture is displayed in the original resolution. The picture will be compressed for other signals.

*4 Aspect ratio is 5:4. This signal is converted to the following signal: 960 dots x 768 lines).

*5 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, set the RGB

mode prepared for the input signals listed in the table above.

*6 To connect the monitor to a Macintosh computer, use the monitor adapter (D-Sub 15-pin) to your computer’s video port.

*7 Other screen modes (LETTERBOX and VIRTUALWIDE) are available as well.

NOTE:

• While the input signals comply with the resolution listed in the table above, you may have to adjust the position and size of the picture

or the fine picture because of errors in synchronization of your computer.

• This monitor has a resolution of 1365 dots x 768 lines. It is recommended that the input signal be VGA, wide VGA or equivalent.

• With digital input some signals are not accepted.

• The sync may be disturbed when a nonstandard signal other than the aforementioned is input.

• If you are connecting a composite sync signal, use the HD terminal.

* “IBM PC/AT” and “VGA” are registered trademarks of International Business Machines, Inc. of the United States.

* “Apple Macintosh” is a registered trademark of Apple Computer, Inc. of the United States.