Operation, Opera t ion – Rhino Mounts NITRO FN10 User Manual

Page 108

OPERATION

FN10/FN15 NITRO 02/10

Operation Section 4-16

OPERA

ION

Engagement Check Procedure

•

With the driveline attached, position the mower to the point where the telescoping driveline is at its maximum
extension. Completely shut down the tractor and secure in position.

•

Mark the inner driveline shield 1/8” from the end of the outer shield.

•

Disconnect the driveline from the tractor and separate the two driveline halves.

•

Measure the distance from the mark to the end of the inner profile. This length is the amount the driveline profiles were
engaged.

•

If the engaged length is less than 6”, the shaft is considered too short and should be replaced with a longer shaft.
Consult an authorized dealer to purchase the required driveline length.

NOTE: If the driveline cannot be shortened and still maintain the required profile engagement, the operator must be made

aware of terrain conditions and avoid situations which pose a potential problem to avoid damaging the driveline or move

drawbar to 16” or 20” position for required clearance. OPS-R-0005_O