RCA P46920BL EN - Manual (Page 38)

38
Features and menus
12:01 CC VCR1 VID1
Mute SAP PIP 59
Sleep 00:00
Channel Marker
There are several indicators that come up when you press the TV, INFO, PIP
or SWAP button. This display is called the Channel Marker.
12:01 Displays the current time.
CC Displayed when Closed Captioning is available on the current
channel.
VCR1 Displays the label assigned to the current channel.
VID1 Displays the current channel or input channel.
Mute (or Stereo) Mute is displayed when you mute the audio. Stereo
is displayed when the current channel is broadcasting in Stereo.
SAP Displayed when the current channel is broadcasting SAP (Second
Audio Program) information.
PIP 59 (PIP Chan) Displays the current PIP channel.
Sleep Displayed when the Sleep Timer has been set.
00:00 Displayed to count down time left on the commercial skip (SKIP)
timer.
Sample displays on a Channel Marker
PIP Problems?
• Make sure the remote is in the right mode. For example, once you
turn on the VCR with the VCR1 button, you can’t SWAP the pictures
until you put the remote in TV mode. Just press the TV button.
• No signal or bad reception? Most VCRs and satellite receivers have
an antenna or TV button. If your cable or off-air antenna goes into
your VCR or satellite receiver, then into your TV, try pressing the
antenna or TV button on the front of the component.
Tip: If programmed to control your VCR, the ANTENNA button on
the remote acts as a TV/VCR button.
• Check the connections. PIP requires a second video source, like a
VCR or satellite receiver, connected to your TV with audio/video
cables. If you use a cable box, you may need extra equipment.
Contact your cable company for more information.
You can program the TV to tune to a
specific channel when you press the VCR1,
SAT•CABLE, DVD and VCR2 buttons. This
is an easy way to tune the PIP window to
the correct video input channel.
Check out the Autotuning feature in the
Interactive Setup and Features and Menus
sections.
To see a different picture in the PIP
window, you must connect another video
source, like a VCR. This connection
requires audio/video cables.
VCR
TV
VIDEO
OUT
IN FROM ANT
OUT TO TV
CH3
CH4
INPUT 1
VIDEO
R
S-VIDEO
R
INPUT 2
VIDEO
CABLE/ ANTENNA
INPUT
S-VIDEO L—AUDIO—R
VCR CONTROL
AUDIO OUTPUT
AUDIO L L AUDIO
+ RIGHT - + LEFT - SPEAKER SELECTION
EXTERNAL INTERNAL
SPEAKERS
R AUDIO L
IN
CABLE, CABLE BOX, OR ANTENNA