RedMax HTZ2460L - Manual (Page 10)

US-10
HTZ2460/HTZ2460L/CHTZ2460/CHTZ2460L
pulling the rope, or remove the spark
plug and dry it.
■ STOPPING ENGINE (OP3)
1. Release the throttle lever and run the
engine for a half minute.
2. Shift the ignition switch to the “STOP”
position.
• Except for an emergency, avoid
stopping the engine while pulling the
throttle lever.
• If the engine won't stop when setting
the ignition switch to the stop position,
close the choke lever and stop the
engine.
In this case, please repair the machine
at your nearest servicing dealer.
■ RUNNING IN THE ENGINE
• During the first 20 working hours, do
not use the hedge-trimmer at maximum
power for long periods.
■ ADJUSTING IDLING SPEED
• Before adjusting the carburetor, clean
the air filter and warm up the engine.
(OP5)
(1) air filter
• Idle screw is adjusted in order to
ensure a good safety margin between
idle running and clutch engagement.
(OP6)
(1) Idle screw
• With the engine idling (3000 rpm),
the blade should not move. We
recommend that you have the dealer
or an authorised mechanic carry out
any carburetor adjustments.
• Weather conditions and altitude may
effect carburation.
WARNING
WARNING
IMPORTANT
NOTE
IMPORTANT
7. Operation
■ STARTING ENGINE
• The cutting head will start moving
upon the engine starts.
1. Feed fuel into the fuel tank and tighten
the cap securely.
2. Rest the unit on a flat, firm place. Keep
the cutting head off the ground and
clear of surrounding objects as it will
start moving upon starting of the
engine.
3. Push the primer pump several times
until overflown fuel flows out in the
clear tube. (OP1)
4. When the engine is cool, move the
choke lever to the closed position.
(OP2)
(1) primer pump
(2) choke lever
(3) close
(4) open
(5) ignition switch
(6) RUN
(7) STOP
(8) throttle lever
5. Set the ignition switch to the “RUN”
position. Release the throttle lever and
make sure it is fully back. (OP3)
6. While holding the unit firmly, pull out
the starter rope quickly until engine
fires. (OP4)
• Avoid pulling the rope to its end or
returning it by releasing the knob. Such
actions can cause starter failures.
7. Move the choke lever to the open
position. And pull out the starter rope
quickly to restart engine.
8. Allow the engine to warm up for a
several minutes before starting
opertion.
1. When restarting the engine
immediately after stopping it, leave the
choke open.
2. Overchoking can make the engine hard
to start due to excess fuel. When the
engine failed to start after several
attempts, open the choke and repeat
NOTE
IMPORTANT
WARNING
OP1
OP2
OP3
[HTZ2460]
[HTZ2460L]
[CHTZ2460]
[CHTZ2460L]
OP4
OP5
OP6