Rockford Fosgate T1500-1bd - Manual (Page 10)

10
S
PECIFICATIONS
MODEL- POWER T500-1bd T1000-1bd T1500-1bd
Continuous Power Rating (RMS) - Measured at 14.4 Battery Volts
4 Load Bridged 250 Watts x 1 350 Watts x 1 500 Watts x 1
2 Load Bridged 400 Watts x 1 650 Watts x 1 1000 Watts x 1
1 Load Bridged 500 Watts x 1 1000 Watts x 1 1500 Watts x 1
Dimensions: Height 2.14" (5.42cm) 2.14" (5.42cm) 2.14" (5.42cm)
Width 8.14" (20.68cm) 8.14" (20.68cm) 8.14" (20.68cm)
Length 11.41" (28.97cm) 13.66" (34.69cm) 14.91" (37.86cm)
Battery Fuse Rating (Amp) External 100A 150A 200A
(Not Supplied)
“A” Weighted Signal to Noise Ratio
Referenced to 1 Watt into 4 ohms ≥80 dB
“A” Weighted Signal to Noise Ratio
Referenced to rated output into 4 ohms ≥100 dB
Crossover Slope 24dB/octave Butterworth
Crossover Frequency variable from 35Hz to 250Hz
Frequency Response 20Hz to 250Hz ±0.5dB
Signal Voltage Adjustment Range Variable from 150mV to 5V (RCA Input)
Protection Short circuit protection shut downs the amplifier in
case of very low impedance or shorted speaker wires.
Thermal switch shuts down the amplifier in case of overheating.
Equalization PEQ (Punch Equalization) Variable from 0dB to +18dB @ 45Hz
Input Impedance 20K ohms
Infrasonic Filter Selectable 12dB/Octave, -3dB @ 28Hz
Operating Voltage 9 to 16 Volts DC
Balanced Inputs Yes
CMRR (Common Mode Rejection Ratio) >55dB @ 1KHz
Damping Factor >200
THD+N (Total Harmonic Distortion + Noise) (T500-1bd) < 0.5% @ 1 ohm
THD+N (Total Harmonic Distortion + Noise) (T1000-1bd) < 0.7% @ 1 ohm
THD+N (Total Harmonic Distortion + Noise) (T1500-1bd) < 0.8% @ 1 ohm
These specifications are Amplifier Power Standard CEA-2006 Compliant
Specifications subject to change without notice