Radio Shack F-350 - Manual (Page 2)

This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult your local RadioShack store or an experienced radio/
TV technician for help.
• If you cannot eliminate the interference, the FCC requires that
you stop using your truck.
Changes or modifications not expressly approved by
RadioShack may cause interference and void the user’s
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
©2004. RadioShack Corporation.
All rights reserved. RadioShack and
RadioShack.com are trademarks
used by RadioShack Corporation.
60-4386
06A04
Printed in China
The FCC Wants You to Know
This product is warranted by RadioShack against manufacturing defects in
material and workmanship under normal use for ninety (90) days from the date
of purchase from RadioShack company-owned stores and authorized RadioShack
franchisees and dealers. For complete warranty details and exclusions, check
with your local RadioShack store.
RadioShack Customer Relations
200 Taylor Street, 6th Floor, Fort Worth, TX 76102
04/04
limited 90-day warranty
• Your truck comes in three frequencies so you and
your friends can play together. If you race other
cars, set your truck and transmitter to a different
frequency than your friend’s.
• If someone uses a CB nearby, it might interfere
with control of your Mattrack. If this happens,
move your Mattrack away from the CB.
hints
Use the supplied box wrench to remove and
replace the mattracks and wheels. When
driving on wheels, use the supplied plastic
washer and wrench to apply the wheels to the
truck.
1. Extend the transmitter’s antenna.
2. Turn on your transmitter and truck. The
headlights and taillights illuminate.
3. Pick a frequency by setting BAND ABC on
the transmitter and the truck to the same
setting.
driving
Do not touch the tires or the steering control
during adjustment.
1. Turn the truck on its side so its tires do not
touch the ground.
2. Turn on the transmitter and truck. If the tires
move, turn Trim I until the tires stop.
3. If the front tires look angled to the left
or right, adjust Trim II until the tires look
straight.
Trim I — adjust so the truck stops completely
when you release the trigger. If Trim I is set
too far right, your truck may continue to drive
forward after you release the trigger.
Trim II — adjust your alignment to drive in a
straight line. If set too far to the left or right, the
truck may veer left or right while driving.
If the truck does not drive in a straight line,
adjust the wheel alignment. If it pulls to the
right, slide the control toward L. If it pulls to the
left, slide the control toward R.
trim adjustment
Use the steering wheel to
steer the truck left and right.
Release it to drive straight.
BAND ABC
Trim I
Trim II
Pull the trigger towards
the handle to drive
forward.
Push the trigger away
from the handle to
drive backward.
Release to stop.