RCA HD44LPW164 - Manual (Page 67)

References
Chapter 5 65
If your TV is connected to an audio/video (A/V) receiver or home theatre system via the DIGITAL AUDIO OUT jack, read the following
information.
• If you’ve connected a component to your A/V receiver, such as a DVD player or satellite receiver, you may experience a slight delay
between the audio heard and the video seen. This occurs because the digital audio is sent directly to the speakers while the video
must be processed inside the TV before it is displayed.
• If the component has Component Video (Y, Pb, Pr) jacks, connect these jacks to the TV’s Y, Pb, Pr jacks to minimize the
discrepancy. This works best if the component supports Progressive Scan technology.
• If necessary, you can connect the component directly to the TV using L/R audio jacks and bypassing the A/V receiver or you can
program an audio delay in the A/V receiver so the audio and video match up (not all audio equipment has the ability to program
delays). Check the audio/video Receiver’s manual.
Blank screen
• Make sure you have connected the component to the TV correctly.
• Make sure the component connected to the TV is turned on and tuned to the corresponding Video Input Channel.
• Try another channel, or press the INPUT or ANT•CAB button.
• When you first turn off your TV, the screen fades from blue to black. Once the screen goes black, the TV’s internal lamp starts its
cool-down cycle. If you try to turn on the TV during the cool-down cycle, the TV turns back on and you’ll hear audio, but the picture
will take a few moments to be displayed.
Unusual sound quality
• Check the Graphic Equalizer, SRS, and Sound Logic settings.
• Check if SAP is turned on.
• Check that the Audio Mode is set to your language.
Humming or buzzing noise
• The TV is in its lamp cool-down cycle. To prolong the life of the TV’s lamp system, the TV must warm up and cool down properly.
You may notice additional noise during these cycles.
• Maybe the speakers are turned off. Check the FIXED/VARIABLE OUT control panel in the Audio menu.
No picture, sound okay
• If the indicator on the front of the TV is blinking for one minute, the lamp inside of your TV may need to be changed. Go to page 72
for ordering information.
• You might have tried to turn on the TV during lamp cool-down. Wait a few moments and the picture will be displayed.
No sound, picture okay
• Maybe the sound is muted. Try pressing the volume up button to restore sound.
• Maybe the speakers are turned off in the Audio Connections menu. Check the FIXED/VARIABLE OUT control panel in the Audio
Connections menu.
• If using an S-Video connection, component video and composite video, remember to also connect the component’s L and R AUDIO
OUT jacks to the TV’s L and R INPUT jacks.
• Check the Maximum and Initial Volume settings in the Special Features menu.
Channel search finds few channels
• The cable connected to the CABLE and/or ANTENNA INPUT jack might be loose.
• Your off-air antenna might be getting a weak signal. Move it higher or get a bigger antenna.
• If you have cables connected to the CABLE and ANTENNA jacks, try swapping the cables. Cable needs to be connected to the CABLE
INPUT; off-air antenna needs to be connected to the ANTENNA INPUT.
• If you have a cable box, you can’t connect it to the ANTENNA jack. Connect it to the CABLE INPUT or a Video Input jack.
• Select all the options in the Channel Search menu, and retry channel search.