Initializing the scanner, Turning off the scanner power, Aaa aa – Ricoh G410 User Manual

Page 27

Text mode
Original mode

2. Setting up the Scanner

Initializing the Scanner

If the SCSI ID rotary switch or DIP switch settings have been changed while the power is on, it
is necessary to initialize the scanner in order to put the new settings into effect. To initialize the
scanner, either turn the power off and then back on again, or else perform the procedure described
below:

Using an object with a thin tip, such as a ballpoint pen, press the reset switch located
on the back of the scanner.
Doing so puts the scanner into the same state as if the power had been turned off and then
back on again.

This manual is related to the following products:

G411