beautypg.com

Power amplifier 2/3 channel – Roksan Audio KMA-2/3 User Manual

Page 8

background image

Roksan Audio ltd

Kandy Power Amplifier 2/3 Channel User Manual

CLASSIFICATION: General Use

Version 1.0

All specifications are liable to change without notice. E&OE

Page 8 of 10

ENGLISH


Please refer to the front and rear panel views on page 4.

SWITCHING ON


The Mains power switch (14) is located on the rear panel of the amplifier. This switch should be left ON for
normal operation. If unattended for a long period, the Mains power should be switched OFF and the lead
disconnected from the power supply.

When switched ON from the rear panel, your Kandy Power Amplifier will go to Operational mode and the MODE
indicator light (1) will glow RED. The amplifier is now ready for use.

1

If there is no signal (or the signal level is very low) the MODE indicator light will change to AMBER after
approximately 2 minutes

2

If there is still no signal after approximately 10 minutes, the amplifier will revert to Standby mode and the
MODE indicator light will glow GREEN

3

As soon as there is a signal the Kandy Power Amplifier will ‘wake up’, the MODE indicator light will glow
RED and after a couple of seconds the outputs will be activated.



USING THE TRIMMERS


Please refer to the rear panel views on page 4.

There are two or

three

Trimmers (7, 8

& 9

) that can be utilised to reduce the gain of any of the channels and

thus reduce the output level on that channel. In this configuration the input signal to that channel must be
connected to its Trimmed Input socket only (not the Straight Input). When connected as such the gain on that
channel can be reduced as indicated below.

NOTE: To avoid damage to the trim pots always use a good quality flat blade electrical trimmer.

















NOTE: These values and positions are approximate and should be used as a guide. During the installation and
set-up, you should adjust the trimmer to achieve the desired output level.








O P E R A T I O N

K a n d y

Power Amplifier 2/3 Channel

Fully Anti-

clockwise

1/8 Turn

clockwise

Fully

clockwise

1/4 Turn

clockwise

3/8 Turn

clockwise

1/2 Turn

clockwise

5/8 Turn

clockwise

Full Gain

31.6 dB

Trimmed

30.4 dB

Full Trim

24.4 dB

Trimmed

29.2dB

Trimmed

28.0dB

Trimmed

26.8 dB

Trimmed

25.6 dB