Russound Advantage In-Ceiling speaker - Manual (Page 19)

19
HOW – Final Assembly of Speakers
TO TEST POLARITY:
Polarity refers to the positive (+) and negative (-) electrical
elements of the speakers, wires, and connections. The test
for polarity ensures that positive and negative wires and
connections are not reversed. This test is performed with
the speaker wires disconnected from the amplifier/receiver.
It is recommended that the wiring and speaker polarity
be tested with a 1.5V AA battery. You’ll need one person
at the speaker end and one person at the exit end of
the speaker wire near the amplifier/receiver.
1. While one person observes the woofer cone (grille
removed for better visibility), the other person momentarily
energizes the wire at the amplifier end with the 1.5V AA
battery (the positive conductor at the positive end, the neg-
ative conductor at the negative end of the battery).
2. If the woofer cone moves outwards when momentari-
ly energized, the speaker is wired correctly. If the woofer
cone moves inward, the polarity is reversed, and the
wire’s positive and negative conductors must be
switched on the back of the speaker.
TO TEST CHANNEL CONNECTIONS:
1. Turn on your stereo system. Make sure that the VOL-
UME control is turned down and that the BALANCE con-
trol is set to center.
2. Activate a musical source such as FM or CD player.
3. Slowly turn up the volume. You should hear music com-
ing out of your new Russound Speakers. (If you don’t, refer
to the troubleshooting guide below.)
4. Make sure sound emanates from all speakers in the system.
5. Now rotate the stereo’s BALANCE control all the way to
the LEFT. Sound should only come from the left speaker. If
sound comes from the right speaker when the stereo’s bal-
ance control is turned to the LEFT, you’ll need to swap the
connections on the back of the amplifier/receiver.
6. FIRST turn DOWN the VOLUME and turn OFF the AMPLIFIER!
7. Swap the wires attached to the left and right speaker ter-
minals.
8. Repeat steps 1 through 5.
A QUICK TROUBLESHOOTING GUIDE
Before seeking service from your Russound dealer,
please read through these troubleshooting tips for sim-
ple remedies.
NO SOUND FROM EITHER SPEAKER:
1. Incorrect source selected on receiver or preamplifier
2. Mute button pressed on receiver
3. Wrong speaker output selected; many receivers have
an “A” and “B” speaker switch
4. In-Wall Volume control not turned up or wired incorrectly
5. If using a speaker selector, room/station not turned
on or improperly connected
6. Short circuit causing amplifier/receiver to power
down or suffer damage
7. Wire disconnected
NO SOUND FROM ONE SPEAKER:
1. Unsecured connection at either the speaker or ampli-
fier/receiver
2. Balance control turned all the way left or right
3. Bad connecting cable between sound source and amplifier
4. Short circuit causing amplifier/receiver to power
down or suffer damage
For any other speaker performance issues, contact your
Russound dealer or call our Tech Services department
at 603-659-5170.