Radio Shack CID 2903 User Manual

Page 11

Preparation

When replacing the batteries, make sure
the CID is unplugged from the telephone
line and AC power, and unplug both
modular line cords from the back of the
CID.

Note: When replacing the batteries, have
fresh ones on hand before you begin. If
you do not install the new batteries within
2 minutes after removing the old ones,
you will lose the time, date, and area code
stored in the CID. (The Caller ID
information, however, remains stored in
the CID's memory.)

1. Use a Phillips screwdriver to remove

the screw from the battery compart-
ment cover, then slide off the cover.

2. Put four fresh AAA batteries into the

compartment as indicated by the
polarity symbols (+ and –) marked
inside.

3. Turn the CID over so you can see the

display. After you install the batteries,

6(7#$5($#&2'(

and

333

appears. The

first

3333

flashes.

4. Within 2 minutes, repeatedly press

REVIEW

until the first digit of your

area code appears, then press