beautypg.com

Installation, Faceplate & trim installation, Flush front installation – Recoton/Advent U31-LP2 User Manual

Page 14

background image

14

FPI U31-2 Gas Fireplace Insert

Diagram 4

Diagram 5

Rear View: Trim Assembly

Diagram 2

Diagram 3

Rear View: Faceplate Assembly

Diagram 1

FACEPLATE & TRIM

INSTALLATION

1) Lay the faceplate panels fl at, face down on

something soft so they don't scratch.

2) Take the top faceplate and align the holes in

it with the holes in the side panels. Using the
screws provided, attach from the top of the
panel (the holes in the top panel are slightly
larger than the holes in the side panel to
facilitate easier installation). Diagram 1.

Hint: Don't tighten the screws down com-

pletely at this point, continue on with steps
3 and 4 and do a trial fi t to the unit. Make
any necessary adjustments and when it fi ts
properly then tighten down the screws.

Hearth Trim Option: Hearth Trim is an
option that can be used to fi nish off the
installation when the bottom of the fi replace
is higher than the hearth or to raise the fi re-
place. Attach the Hearth Trim to the bottom
of the faceplate side panels with the screws
provided. See Diagram 1.

3) Using the connectors provided, join the left

side trim (with the ON/OFF switch) to the
top trim. Diagram 2. Connect the right side
trim to the top trim.

4) Place the trim on the assembled faceplate

panels, aligning the wire connections from
the switches with the notch on the left side
panel.

5) Connect the fan switch wires by taking the

black and red wires with the male ends (in

INSTALLATION

the grey harness) and connect them with
the wire connectors from the fan speed
control.

6) Connect the ON/OFF switch wires by taking

the black and red wires with the female ends
and connect them to the ON/OFF switch.


7) Tuck the wires into the faceplate to keep

them away from the insert using the clip
provided. Attach the clip to the rear of the
faceplate to ensure that the wires do not
touch the side of the unit. Diagram 3.

8) The power cord should be run behind the

faceplate panel.

9) Attach the brass trim to the faceplate by

drilling a 1/8" hole through into the faceplate
using the hole in the trim as a guide. Fasten
the trim to the faceplate panels using the
plated screws. Diagram 4.

10) Attach the faceplate panels to the insert

body using the 4 remaining black screws.
Diagram 5.

11) Push the Regency logo plate into the two

holes in the bottom left corner of the face-
plate.

FLUSH FRONT

INSTALLATION

1) Install Logs before going on to the next

step. See the Log Installation instruction
sheet or page 9.

2) Install the bottom glass trim by hooking the

trim into the lip on the fi rebox base. The trim
will not fi t into place if the glass is installed
fi rst.

This manual is related to the following products: