Ricoh Lens A16 - Manual (Page 30)

0
• If the flash (GF-1) is fired using DISP. in [Manual], the white balance will be
set to the metering results calculated when the flash went off.
[ISO Setting]
[Auto], [Auto-Hi], [ISO-LO], [ISO 200] to [ISO 3200] can be selected.
Note --------------------------------------------------------------------------------------
• [ISO-LO] is equivalent to ISO 100. However, the dynamic range gets
narrower and the higher brightness levels make whiteout more likely to
occur.
• When [Auto] is selected and the flash is used, the sensitivity used will gain
up to ISO 800 equivalent.
• The step setting for ISO can be selected in [ISO Step Setting] (GP. 38) in
the setup menu.
• When [Auto] is selected and the flash is not used, the minimum and
maximum values for the ISO sensitivity will be ISO 200 and ISO 400.