Roland Stage Amplifier SA-1000 - Manual (Page 13)

13
Making the Connections
Switching the Power On and Off
* Once the connections have been completed (p. 12), turn on
power to your various devices in the order specified. By
turning on devices in the wrong order, you risk causing
malfunction and/or damage to speakers and other devices.
1. Make sure that all volume controls on the SA-1000 and
connected devices are set to 0.
2. Turn on all the devices connected to the SA-1000’s
input jacks.
3. Turn on the SA-1000.
4. Switch on any equipment connected to the SA-1000’s
LINE OUT jacks.
5. Adjust the volume levels for the devices.
6. Before switching off the power, lower the volume on
each of the devices in your system and then Turn Off
the devices in the reverse order to which they were
switched on.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
* If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power
outlet. Refer to “Power Supply” (p. 5).
* Even with the volume all the way down, you may still hear
some sound when the power is switched on, but this is normal,
and does not indicate a malfunction.
SA-1000_r_e.book 13 ページ ２００７年１０月１日 月曜日 午後１時５２分