Roland Stage Amplifier SA-1000 - Manual (Page 12)

12
Making the Connections
Refer to the figure shown below to connect the SA-1000 and the other equipment.
fig.02-01
* To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
* When connection cables with resistors are used, the volume
level of equipment connected to the inputs (MIC IN,
KEYBOARD IN, AUDIO IN) may be low. If this happens,
use connection cables that do not contain resistors.
* Before making any connections, set the SA-1000’s MASTER
VOLUME knob to “0.”
• Connect only the SA-1000W with the DEDICATED
SPEAKER juck of SA-1000. Never connect any other
equipment.
• Be sure to use only the connection cable included with
the unit to connect the SA-1000W. Do not use ordinary
audio cables.
Mixer
CD Player
Portable
Audio Player Mic
SA-1000W
INPUT
Keyboard
Organ
Roland
V-Drums
Special connection
cable
SA-1000_r_e.book 12 ページ ２００７年１０月１日 月曜日 午後１時５２分