Roberts Radio Gemini 33 CRD-33 - Manual (Page 22)

21
Operating your radio - Search tuning FM
1. Place the wire antenna so that it is as straight as possible extending
either above or below the radio.
2. Press the Standby button to switch on your radio.
3. Press the Band button to select the FM band.
4. Press and immediately release the Auto tune button, your radio will
scan in an upwards direction (low frequency to high frequency) and
stop automatically when it fi nds a station of suffi cient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio will display the station name.
6. To fi nd other stations, press and release the Auto tune button as
before.
7. To scan the FM band in a downwards direction (high frequency to low
frequency) press and hold down the Auto tune button for 0.5 seconds
and then release.
8. When the waveband end is reached your radio will recommence tuning
from the opposite waveband end.
9. Adjust the Volume and Tone controls to the required setting.
10. To switch off your radio press the Standby button.
4
6,7
2
3
9 9