RCA TruFlat T20TF668 - Manual (Page 14)

12 Chapter 1
Connections & Setup
Initial Setup
The first time you turn on your TV/VCR, you’ll be asked to set a few screens so that your TV/VCR will be set up
correctly. Complete the following steps to set up your TV/VCR.
ENGLISH
ESPANOL
FRANCAIS
SELECT / : SET OK
SELECT LANGUAGE
CONNECT ANTENNA
OR CABLE.
START AUTO CH PRESET?
YES OK
NO MENU
PLEASE WAIT
AUTO PROGRAMMING
AIR 2
STOP OK
Automatically Searching for Channels
The next part of the initial setup asks you if you want to start AUTO CH PRESET
(also called auto programming or auto channel search) – this enables the
TV/VCR to search for all of the channels that are viewable through your cable
TV connection or off-air antenna.
1. If you’ve connected your antenna or cable, press the OK button on the
remote (auto programming starts).
When the search is complete the TV/VCR will automatically tune to the first
channel in the channel list.
To stop, press the OK button on the remote control.
Select a Language
The first time you turn on the TV/VCR, the SELECT LANGUAGE menu appears
on the screen. If you want the on-screen menus to appear in English, press the
OK button on the remote control. If you want the on-screen menus to appear
in a different language, follow these steps.
1. Press the down arrow on the remote to highlight ESPANOL (Spanish) or
FRANCAIS (French).
2. Press OK to select the language.
Note: If you need to change the language later, you can access this menu
from the Main menu - go to page 37 for instructions.