Radio Shack 40-1431 User Manual

Page 2

Po
wer S

ources

1. Press

POWER

to make sure the speakers are off.

2. Press the tab on each speaker’s battery compartment

cover, then remove the cover.

3. Place two C batteries into each speaker’s battery

compartment on top of the attached ribbon, as
indicated by the polarity symbols (+ and –) marked
inside.

4. Replace both of the covers.

If the speakers’ sound weakens or distorts or the POWER
indicator dims during use with batteries, replace the
batteries.

Rý

5+0)

"#%"

"&%"2

19'4

To power the speakers from an AC outlet or your vehicle’s
battery power, you need an AC or DC adapter and a size M
Adaptaplug



(neither supplied, available at your local

RadioShack store).

1. If necessary, set the adapter’s voltage switch to 9V.

2. Attach the Adaptaplug to the adapter’s cord with the tip

set to positive (+).

3. Insert the barrel plug into the right speaker’s

600mA DC

jack. This disconnects the internal batteries.

4. Plug the other end of the adapter into the power

source.

"9#40+0)

Always dispose of old batteries
promptly and properly. Do not
bury or burn them.

"%#76+10"

•

If you do not plan to use the
speakers for a week or more, or
if you plan to use them with AC
power, remove the batteries
from the both speakers.
Batteries can leak chemicals
that can destroy electronic
parts.

•

You must use a (Class
2 for AC) power source
that supplies 9V DC
and delivers at least 600mA. Its
center tip must be set to
positive and its plug must fit the
speakers's 600mA DC 9V jack.
Using an adapter that does not
meet these specifications could
damage the speakers or the
adapter.

•

Always connect the adapter to
the speakers before you plug it
into the power source, and
unplug the adapter from the
power source before you
unplug it from the speakers.

PHONES

600mA DC 9V