RCA MAF15BKR - Manual (Page 3)

English
3 3
Attaching the Arms to the TV
IMPORTANT! Use extra care during this part
of the installation. If possible, avoid placing your
display facedown as it may damage the viewing
surface.
NOTE: This mount comes with a selection
of different screw diameters and lengths to
accommodate a wide variety of display models.
Not all of the hardware in the kit will be used.
If you
cannot fi nd the appropriate screw size in the kit
provided, consult the manufacturer of your display
for more information.
1. Determine the correct length of screw to use by
examining the back of your display:
A. If the back of your display is fl at and the
mounting holes are fl ush with the surface,
you will use the shorter screws (
D or F) from
the hardware kit.
B. If the back of your display is curved, has
a protrusion, or if the mounting holes are
recessed, you will need to use the longer
screws (
E or G ) and spacers ( I ).
2. Determine the correct diameter of screw to use
by carefully trying one of each size (M4 and M6)
from the hardware kit. Do not force any of the
screws – if you feel resistance stop immediately
and try a smaller diameter screw.
3. Attach the mount arms to the back of your
display using the screws identifi ed in Steps 1
and 2 along with the M6 washers (H) (see Fig.6).
If you are using the longer screws on a display
with a curved or recessed back, you will also
need to use the spacers (
I ). You should only
use a spacer if necessary.
Make sure the screws are snug, but do not
overtighten.
For displays with curved or
recessed backs. For displays with
Fig.6
Specifi cations
Final Installation
1. With the help of another person, carefully lift
your display and place it on the wall plate. Do
not release the display until the mount arms
have securely hooked onto the wall plate.
2. Insert the safety bar at the bottom of the mount
to prevent the display from being lifted from
the wall plate. A padlock can be inserted into
the end of the bar to help prevent theft of your
display (
see Fig.7 ).
IMPORTANT! The safety bar must be used
at all times to prevent the display from being
accidentally knocked from the mount.
Safety Bar
Padlock (optional,
not included)
Fig. 7
Periodically clean your mount with a dry cloth. Inspect all screws and hardware at regular intervals to
ensure that no connections have become loose over time. Re-tighten as necessary.
Display Size: 15” to 32”
Maximum Load: 25 kg (55 lbs)
Universal VESA Mounting Pattern: 230 mm x 250 mm (9” x 9.8“) max
Profi le: 2.2 cm (0.9”)
5. Place the wall plate back against the wall and attach it using the
lag bolts (A) and lag bolt washers (B) provided (see Fig. 5)
. Do not
over-tighten these bolts and do not release the wall plate until all
bolts are in place. Ensure that the wall plate remains level after all
bolts are secured.
Fig.5