2 local network setup, Ethernet network, Standard wiring procedure – RCA SpeedTouch 546 User Manual
Page 21: Device settings, Ethernet link check, Local network setup, Chapter 2
13
E-DOC-CTC-20051017-0144 v1.0
Chapter 2
Local Network Setup
2 Local Network Setup
Ethernet network
The Ethernet ports on the back panel of your SpeedTouch™ allows you to connect
the SpeedTouch™ to an existing 10 or 100 Base-T Ethernet network or to a
computer with installed Ethernet card.
Using the SpeedTouch™ Ethernet switch, you can create a local Ethernet network of
up to four devices, without needing extra networking devices
Standard wiring
procedure
Use the yellow Ethernet cable provided to wire your computer’s Ethernet port to the
one of the SpeedTouch™’s Ethernet ports.
The Ethernet cable can also be used to wire any Ethernet port of your
SpeedTouch™ to an external hub or switch.
Device settings
Once you have connected a device, you can personalise its settings. For more
information, see
.
Ethernet link check
Depending on the SpeedTouch™ model, LED indicators allow you to check your
Ethernet. See
“1.1 SpeedTouch™ LED Behaviour” on page 4
for more information.
In the SpeedTouch™ package, a yellow full-wired straight-through RJ-45/
RJ-45 Ethernet cable is included.
Please follow the installation instructions supplied with the external hub or
switch for connections and Ethernet cabling.