RCA SpeedTouch 546 - Manual (Page 19)

11 E-DOC-CTC-20051017-0144 v1.0
Chapter 1
Getting to know your SpeedTouch™
FTP file transfer To allow correct file transfers, set the transfer mode to “binary”: at the ftp prompt,
type
bin and press ENTER.
Example.
Quote site command All the CLI commands can be executed from within an FTP session. Only complete
CLI commands (in other words, the complete command syntax with all the
parameters already specified) can be executed.
Example: To execute the CLI command :ip iplist to list all IP addresses
currently assigned to SpeedTouch™ interfaces, at the FTP prompt, type ‘quote site
ip iplist’ and press ENTER.
For more information on CLI commands, see the SpeedTouch™ CLI Reference
Guide.
Turn on the hashing option to see the progression of the file transfer: At the
ftp prompt, type
hash and press ENTER.
/home/doejohn{1}$ftp 192.168.1.254
Connected to 192.168.1.254
220 Inactivity timer = 120 seconds. Use 'site idle ' to change.
Name (192.168.1.254:doejohn):
331 SpeedTouch™
(00-90-D0-01-02-03) User 'doejohn' OK. Password requir
ed.
Password : ######
330 OK
ftp>
ftp>bin
200 TYPE is now 8-bit binary
ftp>
ftp>hash
200Hash mark printing on (8192 bytes/hash mark).
ftp>cd dl
250 Changed to /dl
ftp>put C:\user.ini
200 Connected to 192.168.1.10 port 1271
150 Opening data connection for user.ini
226 File written successfully
ftp: 256 bytes sent in 0,000Seconds 256000,000Kbytes/sec.
ftp>
ftp> quote site ip iplist
200- Interface Type IP-address Point-to-point/Mask
200- 2 LocalNetwork Ethernet 10.0.0.138 255.255.255.0
200- 2 LocalNetwork Ethernet *192.168.1.254 255.255.255.0
200- 1 Internet Serial 81.240.198.191 81.240.198.1
200- 0 loop Internal 127.0.0.1 255.255.255.255
200-
200 CLI command "ip iplist" executed
ftp>