beautypg.com

Connecting a standard tv – RCA 40 User Manual

Page 7

background image

7

Connecting a Standard TV

Follow these steps to connect the VCP to a standard TV that has a 75-ohm cable jack (but
does not have separate audio and video input jacks).

1. Make sure the TV is off, then disconnect the antenna or cable wire from your TV’s VHF

antenna terminal and connect it to the VCP’s

ANT.IN

terminal.

Notes:

• If your antenna has a 300-ohm wire, connect the wire to the 300-ohm screw terminals

on the supplied 300-to-75-ohm adapter. Then connect the adapter’s 75-ohm
connector to the VCP’s

ANT.IN

terminal.

• If you have a VHF/UHF splitter connected to your TV, disconnect the antenna wire

from the splitter’s input terminal and leave the splitter connected to the TV.

• If you have a separate UHF antenna, leave the UHF antenna wire connected to the TV.

2. Using the supplied 75-ohm coaxial cable, connect the VCP’s

RF.OUT

terminal to the TV’s

VHF antenna terminal (or the splitter’s input terminal). If your TV has only 300-ohm
antenna terminal, use a 75-to-300-ohm adapter (not supplied) to connect the VCP’s
output to your TV.

3. Set the

CHANNEL

switch on the back of the VCP as described under “Setting the Channel

Switch” on Page 10.

3

DC IN 12V

4

CHANNEL

RF.OUT

ANT.IN

VIDEO

OUT

AUDIO

OUT

300-ohm

75-ohm

UHF

VHF

VHF Antenna Terminal

Antenna

CHANNEL

ANT.IN

RF.OUT

TV

VCP

Or

This manual is related to the following products: