beautypg.com

Nb-1900n, Hot laminating – Royal Sovereign NB-1900N User Manual

Page 7

background image

1. Press the power button.

2. Choose setting by or

3. When red LED stops blinking and buzzer rings, you're ready to laminate.

(It takes 4~5 minutes depending on setting function.)

4. Put document to be laminated, into a laminating pouch. Leave a minimum

border of about 3mm(1/8"), to provide a proper edge seal.

5. Insert pouch squarely into opening slot.

6. Finished lamination will exit through rear of machine.

7. Emerging laminated document is hot to the touch.

(Always allow lamination to cool down on a flat surface for about a minute

before handling, to prevent permanent bending. If document is not

laminated well, re-insert it and run it through a second time.)

8. When continuously laminating, run the laminator at a lower setting

because the internal machine temperature may be higher than the

required temperatur, causing the document to bend or ripple.

9. When finished laminating, turn off the machine.

NB-1900N

7

HOT LAMINATING

Sometimes, when continuously laminating, LED may begin
blinking. If this happens, finish laminating the current document,
then wait until the LED stops blinking, before inserting the next
lamination.

'***USEFUL INFORMATION***

* Do not laminate empty or thin pouch on a thick film setting.
The pouch could stick to the roller.

* Do not unplug laminator while laminating.
This could be fatal for the rollers due to the high internal temperature.