Rangemaster 90 INDUCTION U109941 - 02 - Manual (Page 17)

15
Door Panel
Open the oven door slightly and remove the front panel
fixing screws from the door sides, two each side (Fig.5-7).
Carefully lift off the outer door panel. The inside face of the
glass panels can now be cleaned – take care not to disturb or
wet the door insulation.
The door is triple glazed but the inner two panels are fixed
and should not be separated. After cleaning, carefully refit the
outer door panel and replace the side fixing screws.
‘Cook & Clean’ Panels
The main oven has side ‘Cook & Clean’ panels which have
been coated with a special enamel that partly cleans itself.
This does not stop all marks on the lining, but helps to reduce
the amount of manual cleaning needed.
These panels work better above 200°C. If you do most of your
cooking below this temperature, occasionally remove the
panels and wipe with a lint free cloth and hot soapy water.
The panels should then be dried and replaced and the oven
heated at 200°C for about one hour. This will ensure that the
panels are working effectively.
Removing the Panels to clean the Enamel
Interior
If you wish to clean the enamel interior of the oven, you will
need to remove the shelves, followed by the ‘Cook & Clean’
panels. Each side of the oven is fixed with four fixing screws.
You do not have to remove the screws to remove the oven
panels. Simply lift each side panel upwards, slide them off the
screws and then pull them forwards (Fig.5-8).
Once the panels have been removed, the oven enamel
interior can be cleaned.
DO NOT use steel wool, oven cleaning pads, or any other
materials that will scratch the surface.
The Tall Oven
To clean the oven sides, slide out the shelves, unhook the
supports from the oven sides and lift out (Fig.5-9).
ArtNo.320-0002a Proplus oven door side screws
Fig.5-7
ArtNo.320-0008 Removing the oven lining
Fig.5-8
ArtNo.320-0022 Tall oven side support
Fig.5-9