Accessories – Ryobi WS730 User Manual
Page 16
16 — English
BRUSH REPLA
CEMENT
See Figure 29
, page 23
.
The saw has externally accessible brush assemblies that
should be periodically checked for wear.
Proceed as follows when re
placement is required:
Unplug the saw.
WARNING:
Failure to unplug the saw could result in accidental start-
ing causing serious injury.
The following recommended accessories are currently available at retail stores:
080009002119 Water Pump
A18WS07
Stand
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or
accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended
can result in serious personal injury.
ACCESSORIES
Remove brush cap with a screwdriver. Brush assembly is
spring loaded and will pop out when you remove brush
cap.
Remove brush assembly.
Check for wear. Replace both brushes when either has
less than 1/4 in. length of carbon remaining.
Do not
replace one side without replacing the other.
Reassemble using new brush assemblies. Make sure
curvature of brush matches curvature of motor and that
brush moves freely in brush tube.
Make sure brush cap is oriented correctly (straight) and
replace.
Tighten brush cap securely.
Do not overtighten.
MAINTENANCE
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 17 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.