Ryobi WS730 - Manual (Page 11)

11 — English
INSTALLING CLEAR HOSE TO WATER
CONNECTION
See Figure 10, page 20.
 Attach the clear hose into the water supply valve con-
nection on the inside of the water tray.
TILE CUTTING WHEEL
For maximum performance and safety, it is recommended
that you use the 7 in. cutting wheel provided with your
saw. Additional cutting wheels of the same high quality are
available at your local dealer.
WARNING:
Do not use cutting wheels rated less than the no load
speed of this tool. Failure to heed this warning could
result in personal injury. Do not use wheel with cracks,
gaps, or teeth.
WARNING:
To prevent possible electrical hazards, have a qualified
electrician check the line if you are not certain that it is
properly wired.
INSTALLING TILE CUTTING WHEEL
See Figures 11 - 13, page 20.
WARNING:
A 7 in. tile cutting wheel is the maximum wheel capacity
of the saw. Never use a wheel that is too thick to allow
wheel washer to engage with the flats on the spindle.
Larger wheels will come in contact with the wheel guard,
while thicker wheels will prevent the wheel bolt from se-
curing the wheel on the spindle. Either of these situations
could result in a serious accident and can cause serious
personal injury.
 Unplug the saw.
 Loosen the wheel guard lock.
 Rotate wheel guard back to expose the arbor nut.
 Fit the wheel wrench on the arbor nut then the hex key
in the spindle.
 Holding the hex key in place to prevent the wheel from
moving, turn the arbor nut counterclockwise. Remove
the hex key, wheel wrench, arbor nut and outer washer.
Do not remove the inner washer.
 Wipe a drop of oil onto inner washer where it contacts
the wheel.
ASSEMBLy
WARNING:
If inner washer has been removed, replace it before
placing wheel on spindle. Failure to do so could cause
an accident since the wheel will not tighten properly.
Never use wheels that have openings, grooves, or teeth
on this tool.
 Place the cutting wheel onto spindle.
 Replace outer blade washer. The double “D” flats on the
blade washers align with the flats on the spindle.
 Using hex key and wheel wrench, tighten arbor nut
securely.
 Retighten the wheel guard lock securely.
INSTALLING THE RIP GUIDE
See Figure 14, page 21.
 Place the rip guide in the unlocked position (lever up).
 Fit the rip guide onto the permanent fence on the Easy
Glide Table™.
 Lock the rip guide in place by pushing the lever down.
INSTALLING THE BEVEL BLOCK
See Figure 15, page 21.
 Place the bevel block in the unlocked position (lever
up).
 Fit the bevel block tab into the slot and onto the perma-
nent fence on the sliding table.
 Lock the bevel block in place by pushing the lever
down.
NOTE: The bevel block should only be used on the right
side of the Easy Glide Table™.
CONNECTING GARDEN HOSE TO THE TILE
SAW
See Figure 16, page 21.
The water supply must come from a fresh water main. NEVER
turn the water supply on high.
 Uncoil the garden hose.
 With the water main faucet turned completely off, attach
the end of the garden hose to the water supply valve.
Tighten by hand.
 Secure hose to the water tray as shown.
The water supply valve provides a convenient on/off for
starting, stopping, and adjusting the water flow onto the
wheel. When used properly, the water supply valve adjusts
the water flow to the perfect, optimal rate.