Using the vpap iv and vpap iv st, Setting up your vpap, Iv and vpap iv st – ResMed Positive Airway Pressure Device VPAP IV User Manual
Page 6: Using the vpap
3
Using the VPAP IV and VPAP IV ST
En
gli
sh
At a fixed flow rate of supplemental oxygen flow, the inhaled oxygen concentration
will vary, depending on the pressure settings, patient breathing pattern, mask
selection, and the leak rate.
!
WARNING
Always use the ResMed Oxygen Connector Port when adding supplemental
oxygen at the flow generator outlet.
Using the VPAP
IV and VPAP IV ST
Setting up your VPAP
1
Connect the power cord to the socket at the rear of your VPAP.
2
Plug the other end of the power cord into the power outlet.
3
Connect one end of the air tubing firmly onto the air outlet.
4
Connect the assembled mask system to the free end of air tubing.
For information on assembling your mask, see your mask manual.
!
WARNING
•
Make sure the power cord and plug are in good condition and the
equipment is not damaged.
•
Only ResMed air tubing should be used with the device. A different type of
air tubing may alter the pressure you actually receive, reducing the
effectiveness of your treatment.
•
Blocking the hose and/or air inlet of the device while in operation could lead
to overheating of the device.
1
2
3
4