Roberts Radio CR9937 - Manual (Page 22)

Operating your radio using RDS (Radio data system)
1. Switch on your radio and select the FM waveband.
2. Tune into a station; the display will indicate frequency for two
seconds and then change to show the station name. The
symbol will appear in the display.
3. If the station does not carry RDS information only the station frequency
will be shown.
Note: the RDS indicator will flash if the signal is too weak for RDS
operation.
Display Modes
After tuning to an RDS station, the display briefly indicates the stations
frequency and then the station name.
1. To display the stations frequency press the Display button
twice; the display briefly indicates the frequency followed by the
station name. If the station is not transmitting an RDS signal or the
signal is too weak, station frequency will be displayed instead of
station name.
2. To return to time display press the Display button once.
21
1 2