Rangemaster RC60 - Manual (Page 6)

4
 Always take care before touching the surface, even
when the hob is turned off. It may be hotter than you
think!
Residual Heat Indicator, ‘H’
After use, a cooking zone will remain hot for a while as heat
dissipates. When a hot cooking zone is switched off the
residual heat indicator symbol, ‘H’, will appear in the display.
This shows that the cooking zone temperature is above 60°C
and may still cause burns. Once the temperature has dropped
to below 60°C the ‘H’ will go out.
The Control Panel
The control panel consists of touch controls to operate the
4 cooking zones, the timer and child lock features (Fig.2-5).
Operating The Hob
To switch on the hob press the On/Off key for about
2 seconds. Each of the cooking zone digital displays will
illuminate, showing ‘0’ and a flashing dot (Fig.2-6).
Note: If further hob functions are not activated within
20 seconds it will automatically shut down.
To activate a cooking zone:
Select the required cooking zone by pressing the ‘+’ on the
appropriate control. A red ‘dot’ will illuminate on the selected
display to indicate that the zone has been selected. Note that
only one cooking zone can be selected at any one time.
To increase the power level, press the ‘+’ key, up to a
maximum of ‘9’ (Fig.2-7).
Note: The ‘+’ keys have a repeat function: holding the key
pressed down will increase the power setting by one level
every 0.3 seconds.
ArtNo.317-0001 60 Touch controls common
ELECTRONIC CONTROL
�
�
�
�
�
�
�
�
Fig.2-5
1. Power ON/Power OFF
2. Cooking zone +
3. Cooking zone –
4. Digital display 5. Zone selection indicator
6. Timer control
7. Timer display
8. TImer indicator lights (4 off)
ArtNo.317-0002 60 On-off controls
Fig.2-6
ArtNo.317-0003 60 Selecting a zone +
Fig.2-7
ArtNo.317-0004 60 Reducing power
Fig.2-8