Radio Shack 21-1679 - Manual (Page 18)

18
RF Emissions Information
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult your local RadioShack store or an experienced radio/TV
technician for help. If you cannot eliminate the interference, the FCC
REQUIRESTHATYOUSTOPUSINGYOURPRODUCT#HANGESORMODIÞCATIONS
not expressly approved by RadioShack may cause interference and
void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
7ARNINGS
• Any adjustment to this equipment is recommended to be
performed by or under the immediate supervision and responsibility
OFAPERSONCERTIÞEDASTECHNICALLYQUALIÞEDTOPERFORMTRANSMITTER
maintenance and repair duties in the private land mobile services
ANDÞXEDSERVICESBYANORGANIZATIONORCOMMITTEEREPRESENTATIVEOF
users of those services.
• Replacement of any transmitter component (crystal, semiconductor,
etc.) for this equipment could result in violation of FCC rules.
RF Emissions Information