15 vista mini installation and operation manual – Rose electronic Vista Mini User Manual
Page 19

Reset com-
mand
Resets and enables mouse and keyboard,
enables PS/2 mouse on currently selected
port.
Send null to
mouse
Used to re-synchronize PS/2 mouse which
has gotten out-of-sync.
Reset com-
puter mouse
zero)
Used to reset computer’s mouse
Identify ROM
version
Identifies ROM version, CPU must be at
some sort of command prompt to receive
value.
Keep settings
Tells Vista Mini to save current scan state
and custom settings of commands shown
below.
Scan time in-
terval
where xx is time in sec-
onds from
1-15 seconds
Sets the time, in seconds, that Vista Mini will
pause at each port when scanning.
Note: Follow with Keep command.
Set keyboard
mode
Select port, then enter
command:
where x is 1, 2, or 3
Sets Vista Mini CPU’s keyboard mode. Used
when CPU is booted before being con-
nected to Vista Mini.
Note: Follow with Keep command.
Set typematic
value
where xxx is a
1–3 digit number’ from 0
to 127 indicating KB
typematic value
Sets power-on keyboard typematic action
which is controlled by the Vista Mini. This can
be used to adjust the key stroke rate and de-
lay to the user preferred setting. See Tables 4
and 5 for how the typematic value is deter-
mined.
Note: Follow with Keep command.
Set mouse
type
Select port, then enter
command
where x is a 0 for a regu-
lar PS/2 mouse, 1 for a
serial mouse, and 2 for a
PS/2 wheel mouse.
Enable/disable PS/2 to serial mouse trans-
lation. Must be done for each computer
where translation is desired by switching to
it and issuing the command.
Also enables/disables wheel mouse com-
munication. Issue the command for each
computer which has a wheel mouse.
Requires a PS/2 mouse.
Note: Follow with Keep command.
15
VIStA MINI INSTALLATION AND OPERATION MANUAL