Radio Shack DX-350 - Manual (Page 5)

5
1. Open the battery compartment by pushing the cover in the
direction of the arrow.
2. Install four AA batteries in the battery compartment as indi-
cated by the polarity symbols (+ and –) mark on the back of the
receiver. Place the batteries on top of the ribbon so you can
easily lift them out later.
3. Replace the cover.
USING STANDARD AC POWER
You can power the receiver from standard AC power with an AC
adapter (such as Cat. No. 273-1454, not supplied).
Insert the adapter’s small connector into the receiver’s DC 6V jack.
Then plug the adapter into a standard AC outlet. Internal batteries
automatically disconnect.
Caution: The recommended adapter supplies 6 volts DC and deliv-
ers at least 150 milliamps with its center tip set to negative. Using
an adapter that does not meet these specifications could damage
the receiver or the adapter.
Illustration of DC 6V jack
w/adapter cord to AC outlet
20-209A.fm Page 5 Wednesday, August 4, 1999 8:36 AM