RCA F19430 - Manual (Page 8)

6
Setup and Connections
VIDEO IN
AUDIO
L R ANT
IN
Once you have made your connections,
you will need to program the TV to tune
to the video input channel in order to see
and hear audio and video from a
component such as a VCR or DVD player.
ANT (Antenna)
Receives the signal
from a cable, cable
box, or off-air
antenna. Also used
for basic
component
connections.
VIDEO and AUDIO Inputs
Connect any one of the following components:
• VCR
• Internet Access Device
• Laserdisc Player • DVD Player
• Satellite Receiver
To view the component connected to the AUDIO
and VIDEO jacks, use the INPUT button on the
remote.
Note: if you plug a component into the front of the
TV, the jacks on the back of the TV will not operate.
Back of the TV
The diagram below describes each of the back panel jacks. When
connecting A/V cables, be sure to connect corresponding jacks (Video to
Video and Audio to Audio). On Model F19430, be sure to connect Right
Audio to Right Audio and Left Audio to Left Audio between stereo
components).
Advanced Connections
Advanced connections give you better sound and video by separating
the audio and video signals and enabling you to connect multiple
components.
This section describes the types of inputs available on the back of your
TV and suggests ways you can use them for optimum performance.
Please note that Model F19420 has one
mono AUDIO jack. Model F19430 has
stereo AUDIO jacks.
Model F19430 AUDIO JACKS: Be sure to connect the
left Audio jack of the component to the Left AUDIO IN
jack of the TV (next to VIDEO IN jack) and the Right
Audio jack of the component to the Right AUDIO IN jack
of the TV.
Note: If you are connecting a mono component, connect
the Audio jack to the Left AUDIO jack of the TV.
Model F19420 AUDIO JACK: Connect
the Audio jack of the component to the
AUDIO IN jack of the TV.
Note: If you are connecting a stereo
component, you may need a y-adapter.
VIDEO JACK: Connect the Video jack of
the component to the VIDEO IN jack of
the TV.