Ryobi BENCH GRINDER BGH826 - Manual (Page 7)

Page 7
LOOSE PARTS LIST
LOOSE PARTS LIST
The following items are included with your Bench Grinder:
■ Shield Rods – one left, one right ................................ 2
■ Shield Rod Brackets with Hardware ........................... 2
■ Safety Shields ............................................................. 2
■ Spark Deflectors ......................................................... 2
■ Work Rests – one left, one right ................................. 2
■ Lock Washers (5 mm) ................................................. 2
ADJUSTABLE WRENCH
Fig. 2
TOOLS NEEDED
The following tools (not included) are needed for assembly and alignment:
7 mm, 10 mm, and 12 mm
COMBINATION WRENCH
PHILLIPS SCREWDRIVER
■ Carefully remove all parts from the shipping carton.
■ Lift the bench grinder from the carton and place it on a
level work surface.
■ Do not discard the packing materials until you have care-
fully inspected the machine, identified all loose parts, and
satisfactorily operated your bench grinder.
■ Examine all parts to make sure no breakage or damage
has occurred during shipping.
■ If all parts have been included, proceed to assembly.
■ If any parts are damaged or missing, do not attempt to
UNPACKING
plug in this tool or turn it on until the damaged or missing
parts are obtained and installed correctly.
■ Contact your nearest Ryobi dealer or call 1-800-525-2579
in the United States or 1-800-265-6778 in Canada for
assistance if any parts are missing or damaged.
WARNING:
If any parts are missing do not operate this machine until
the missing parts are replaced. Failure to do so could
result in possible serious injury.
■ Washers (5 mm) .......................................................... 2
■ Washers (8 mm) .......................................................... 2
■ Phillips Screws (5 mm x 8) ......................................... 2
■ Hex Bolts (8 mm x 14) ................................................ 2
■ Hex Bolts (5 mm x 10) ................................................ 2
■ Operator's Manual