RIDGID R3202 - Manual (Page 18)

18
WARNING:
Before performing any adjustment, make sure the
tool is unplugged from the power supply and the
switch is in the
OFF position. Failure to heed this
warning could result in serious personal injury.
POSITIVE 0° BEVEL STOP
See Figures 21 - 22.
The saw has a positive 0° bevel stop that has been factory
adjusted to assure 0° angle of the saw blade when making 90°
cuts. However, misalignment can occur during shipping.
To check positive 0° bevel stop:

Unplug the saw.
 Place the saw in an upside down position on a
workbench.
 Move the lower blade guard out of the way so that the
saw blade is exposed.
 Check the squareness of the saw blade to the base of
the saw using a combination square.
To adjust positive 0° bevel stop:

Unplug the saw.
 Pull bevel adjustment lever upward to release.
 Turn TORX
®
T-8 adjustment screw with TORX
®
T-8 wrench
and adjust base until it is square with the saw blade.
 Securely lock the bevel adjustment lever.
WARNING:
Attempting a bevel cut without having the bevel
adjustment lever securely locked in place can
result in serious injury.
56
0
56
Fig.
BEvEL
ADJUSTMENT LEvER
COMBINATION
SQUARE
BLADE
ADJUSTMENTS
POSITIvE 0º
BEvEL STOP
Fig. 1
TORx
®
T-8
wRENCH
TORx
®
T-8
ADJUSTMENT
SCREw
TORx
®
T-8
ADJUSTMENT
SCREw
TORx
®
T-8
ADJUSTMENT
SCREw