beautypg.com

Rear panel – RBH Sound SA-200 User Manual

Page 4

background image

The following describes the control functions of the rear panel of the

amplifier (refer to figure 2).
8. Line/LFE Input: These RCA type terminals are for the pre-amp

level input signals coming from a processor or preamplifier labeled

“subwoofer” or “LFE.”

IMPORTANT! Use either the Line Level inputs or the “Speaker Level”

inputs separately. DO NOT use both, as damage to the receiver and/or

the Subwoofer Amplifier may result.

WARNING! DO NOT connect an amplified or speaker-level signal into

the line/LFE input(s).

9. Line/LFE Output: These RCA type terminals carry the same audio signal

as the line inputs. These terminals are used if an output signal is needed

elsewhere in your system. These outputs are full-range outputs.

10. Speaker Level Output: This 100Hz high-pass speaker output is for your

satellite/main speakers. The built-in crossover limits the frequencies

below 100Hz from being sent to your satellite/main speakers. You may

use these speaker outputs only when using the “Speaker Level” input

terminals (#11). Connect your satellite/main speakers (observing the

proper polarity) to the binding posts labeled “Speaker Level Out.”

NOTE: These connectors are not powered by the Subwoofer Amplifier.

11. Speaker Level Input: These connectors are for the amplifier or speaker-

level audio output from an amplifier or receiver.

IMPORTANT! Use either the Line inputs or the “Speaker Level” inputs

separately. DO NOT use both, as damage to the receiver and/or the

Subwoofer Amplifier may result.

12. Subwoofer Output: This is the amplified audio output of the Subwoofer

Amplifier. If the Crossover Button (#5) is in the “on” position, the audio

output will be limited to the lower frequencies selected by the Frequency

Control (#6). If the Crossover Button (#5) is in the “off” position, the

audio output will be full-range. An impedance load of 4-16 ohms may be

connected to this output. Please follow the instructions in the connections

section of this owner’s manual for proper wiring information.

13 Dimmer: This knob adjusts the brightness of the indicator lights on the

front panel.

Rear Panel

3