RCA P46921 - Manual (Page 6)

Setup and Connections
4
Step 1: Unpack the TV
Make sure to locate the remote control.
Step 2: Connect Your TV
In order to protect against power surges:
• Connect all components before plugging any power cords into the
wall outlet.
• Turn off the TV and/or component before connecting or
disconnecting any cables.
• Make sure all antennas and cables are properly grounded. Refer to
the Safety Tips sheet packed with your TV.
Cautions:
Position cables to Avoid Audio Hum or Interference
• Insert all cables firmly into jacks.
• Place the audio/video cables to the sides of the TV’s back panel
instead of straight down the middle.
• Try not to coil any twin-lead cables and keep them away from the
audio/video cables.
Protect your components from Overheating
• Do not block ventilation holes in any of the components. Arrange
the components so that air can circulate freely.
• Do not stack components.
• Allow adequate ventilation when placing your components in a
stand.
• Place an amplifier on the top shelf of the stand so heated air rising
from it will not flow around other components.