Ryobi CS30 ZR30000 - Manual (Page 18)

Page 18
STOP
OPERATION
Fig. 22
Fig. 21
THROTTLE
TRIGGER
IGNITION SWITCH
STARTER GRIP
THROTTLE TRIGGER
IGNITION
SWITCH
STARTING
INSTRUCTION
LABEL
PRIMER BULB
STARTING AND STOPPING
See Figures 21, 22, and 23.
Trimmer should be on a flat, bare surface for starting.
1. Slowly press the primer bulb seven (7) times.
2. Set the choke lever to the FULL CHOKE position (A).
3. Squeeze the throttle trigger fully and pull starter handle
sharply until engine attempts to run. Do not pull the
starter handle more than eight (8) times.
NOTE: Keep throttle trigger squeezed fully through
STEP 6.
4. Set the choke lever to the HALF CHOKE position (B).
5. Pull the starter handle until the engine runs. Do not pull
the starter handle more than six (6) times.
6. Allow the engine to run for 15 seconds, then set the
choke lever to the RUN position (C).
TO STOP THE ENGINE:
See Figure 21.
To stop the engine, depress the switch to the stop
position “
”.
IF ASSISTANCE IS REQUIRED FOR THIS PRODUCT:
Do not return this product to the retail store where it was
purchased. Please call our Customer Service Department
for any issues you may have.
For Help Call: 1-800-860-4050
HALF
CHOKE (B)
FULL
CHOKE (A)
RUN (C)
CHOKE LEVER
Fig. 23