Ryobi JM82 - Manual (Page 20)

20 21
MAINTENANCE
WARNING:
When servicing, use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power tool operation or when blowing
dust. If operation is dusty, also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Electric tools used on fiberglass material, wallboard, spackling
compounds, or plaster are subject to accelerated wear and
possible premature failure because the fiberglass chips and
grindings are highly abrasive to bearings, brushes, commu-
tators, etc. Consequently, we do not recommended using this
tool for extended work on these types of materials. However,
if you do work with any of these materials, it is extremely
important to clean the tool using compressed air.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrica-
tion is required.
REPLACING THE BLADE
See Figures 22 - 24.
After extended use, the blade on your biscuit joiner may
become dull and need replacing. If you accidentally hit a nail
or other blunt object, it will break the carbide tips, which will
require replacing the blade.
n
Unplug the biscuit joiner.
n Remove the dust bag.
n Place the biscuit joiner upside down on a workbench.
n With a screwdriver, remove the four screws and washers
that connect the shoe to the front and rear assemblies.
Remove the shoe.
SHOWN WITHOUT DUST BAG
Fig. 22
SHOE
SCREW(S)