Roberts Radio RD-12CFM User Manual

Page 15

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri)

The wire coloured BLUE must be connected to the terminal marked N or
coloured BLACK.

The wire coloured BROWN must be connected to the terminal marked L
or coloured RED.

Mains supply

The RD-12CFM will operate from a supply of AC 230 volts, 50Hz

only.

DO NOT cut off the mains plug from this equipment. If the plug
fitted is not suitable for the power points in your home or the cable is too
short to reach a power point, then obtain an appropriate safety approved
extension lead or adaptor. If in doubt consult your dealer.

If nonetheless the mains plug is cut off, remove the fuse and dispose of
the plug immediately to avoid a possible shock hazard by inadvertent
connection to the mains supply.

If this product is not supplied with a mains plug, or one has to be fitted,
then follow the instructions given below:

IMPORTANT. DO NOT make any connection to the larger terminal which

is marked with the letter E or by the safety earth symbol

or coloured

Green or Green-and-yellow.

The wires in the mains lead are coloured in accordance with the following
codes :-

BLUE - NEUTRAL BROWN - LIVE

Fuse

When replacing the fuse only a 3A ASTA approved to BS1362 type
should be used and be sure to re-fit the fuse cover.

IF IN DOUBT - CONSULT A QUALIFIED ELECTRICIAN.

Replacement fuse holders are available from Roberts Radio Technical
Services at the address shown on the rear of this manual.

RD12-CFM Issue 2.pmd

5/25/2005, 11:42 AM