Ryobi BTS15 - Manual (Page 16)

Page 16
ASSEMBLY
TO MOUNT THE TABLE SAW TO THE LEG
STAND
See Figure 9.
■ Take the following from a small hardware bag:
4 hex bolts (5/16-18 x 2 in.)
4 hex nuts, flanged (5/16-18)
4 flat washers (5/16 in.)
Note: This hardware was in the bag with hardware for
assembling the leg stand.
WARNING:
The saw base is heavy. Do not lift the saw without help.
When lifting, lift close to your body. Keep your knees bent
and lift with your legs, not your back. Ignoring these
precautions can result in back injury.
■ Place the table saw on the leg stand. Align the holes in the
table saw base with the holes in the upper braces.
■ Place a flat washer on a hex bolt and insert through hole.
Add a flanged hex nut. Hand tighten. See Figure 9.
■ Repeat for three remaining holes. Tighten all hardware
with a wrench. You may find it helpful to use one wrench
to hold the head of the hex bolt and one to tighten the hex
nut.
WARNING:
Do not connect to power supply until assembly is com-
plete. Failure to comply could result in accidental starting
and possible serious injury.
TO INSTALL THE BLADE ADJUSTING HANDLE
See Figure 10.
The blade adjusting handle mounts to the bevel handle with
a screw (M4 x 10 mm) and a flat washer.
■ Align blade adjusting handle to the shaft end that extends
from the front of the table saw base. Match the flat spots
on the shaft with the flats inside the blade adjusting
handle. Insert a screw and a flat washer in the center of
the blade adjusting handle and tighten.
Fig. 9
SHAFT END
SCREW
WASHER
Fig. 10
HEX BOLT
FLANGED
HEX NUT
FLAT
WASHER
LEG STAND
SAW BASE
BLADE
ADJUSTIING
HANDLE
BEVEL
HANDLE