Radio Shack 43-3823 - Manual (Page 34)

34
Troubleshooting
If you still have problems, disconnect the phone. If other phones on the same line
work properly, the fault is in this phone or its installation. If you cannot find the
problem, take your phone to your local RadioShack store for assistance.
Messages are
incomplete.
The incoming messages may be too long. Remind callers to
leave a brief message.
The memory may be full. Delete some or all of the saved
messages.
After a power failure, the
outgoing message is
deleted.
Record your personal outgoing message again. The default
message should remain.
No sound on the base
unit speaker during call
monitoring or message
playback.
Adjust the speaker volume on the base unit.
Cannot access remote
call-in features from
another
touch-tone phone. Make sure you’re using the correct PIN code.
Make sure that the touch-tone phone you’re using can transmit
the tone for at least two seconds. If it cannot, you may have to
use another phone to access your messages.
Problem Solution
43-3823.FM Page 34 Thursday, March 27, 2003 10:22 AM