Roland DIGITAL SNAKE S-4000D - Manual (Page 7)

7
Panel Descriptions
REAC Ports 1–10
You can connect the master REAC device to the desired REAC port and split its output to
other REAC ports.
REAC ports 3 to 10 are compatible with REAC EMBEDDED POWER, and can supply power
to devices compatible with REAC EMBEDDED POWER.
When a REAC device is connected, the system automatically detects whether the device is
compatible with REAC EMBEDDED POWER and supplies power if compatible.
Power is not supplied if the device is not compatible with REAC EMBEDDED POWER.
POWER/LINK/ACT Indicators
These indicate the status of the ports. The indicators function as follows.
POWER Indicator
Powering up the unit makes the POWER indicator light up.
[POWER] Switch
This switches the power on and off.
Front Panel
Status
Indicator
Red
(POWER)
Green
(LINK) Yellow
(ACT)
With nothing connected Off Off Off
When supplying power to a REAC EMBEDDED POWER device Lit – –
When enabled for transmission – Lit Lit
When communicating with another REAC device – Flashing Lit
• Never connect any equipment
other than REAC devices to
REAC ports 3 through 10.
• REAC ports 1 and 2 do not
support REAC EMBEDDED
POWER.
Connect devices compatible
with REAC EMBEDDED POWER
to REAC ports 3 through 10.
S-4000D_e.book 7 ページ ２００９年５月２５日 月曜日 午前１１時４６分