Radio Shack PDCD810 - Manual (Page 11)

- 10 -
BEFORE SWITCHING OFF THE POWER
When you have finished using the CD player, before switching off the power, ensure that the disc is ejected.
Do not switch off the power when the
disc in the loader.
POWER OFF
Switch off the power after the disc is
ejected.
POWER OFF
TROUBLESHOOTING GUIDE
If difficulties arise with your compact disc player, locate the apparent problem in the left-hand column of the table and follow the
corrective action suggested in the right-hand column.
1. Is the compact disc player properly connected to the amplifier?
2. Is the amplifier set for the proper operation?
3. Have the operating instructions for the compact disc player been followed?
Symptom Possible Cause Corrective Action
The power fails to switch on
when the POWER switch is set
to ON
Poor power plug connection at the AC outlet. Insert the power plug firmly into the AC outlet.
Disc play does not start
The disc is loaded upside down.
The disc is too dirty. Reload the disc with the label side up.
Clean the disc.
No sound
Improper output cable connections.
Improper amplifier operation.
Connect the output cable properly.
Make sure that the amplifier controls are set
properly.
Sound skips
The CD player is subject to vibrations or
physical shock. Change the installation location.
Hum Loose cable connections. Firmly connect all audio plugs.