Radio Shack TAD-1006 - Manual (Page 22)

22
Checking/Deleting the
Announcement-Only
Message
You can press OGM while the ANN in-
dicator is turned on to play the an-
nouncement-only message. Adjust
VOLUME on the side of the TAD to a
comfortable listening level.
To stop listening to the message be-
fore it ends, press
ON/OFF .
To delete your recorded announce-
ment-only message, press
DELETE/
PROG while the TAD is playing it.
Note: If you delete your recorded an-
nouncement-only message, to use the
announcement-only feature again,
you must first record another an-
nouncement-only message. Other-
wise, the TAD will not answer calls.
SCREENING CALLS
To screen your calls, let the TAD an-
swer all calls for you, and listen to the
caller’s message through the TAD’s
speaker. If you decide to answer the
call, pick up any phone connected to
the same phone line as the TAD. The
TAD stops recording and resets to an-
swer the next call.
Note: If you pick up the phone just as
the TAD answers, the TAD might not
stop recording. If this happens, hang
up the phone momentarily, then pick it
up again.
RECORDING A 2-WAY
CONVERSATION
You can record both sides of a con-
versation on the TAD-1006’s built-in
phone or on any phone connected to
the same phone line as the TAD-
1006.
At any time during the conversation,
press and hold
2-WAY for about 2 sec-
onds. The ANSWER indicator flashes,
and the TAD beeps once, then begins
recording.
To stop recording, press ON/OFF . The
ANSWER indicator stops flashing, the
TAD beeps once, and recording stops.
Notes:
• It is illegal in some states to record
a conversation without the con-
sent of all parties to the conversa-
tion, including the phone
company. Check the laws in your
area before using the 2-way
record feature.
illustration
43-768.fm Page 22 Friday, August 13, 1999 2:49 PM