Radio Shack TAD-1027 - Manual (Page 11)

11
PLAYING MESSAGES
If there are new messages, the PLAY/
SKIP indicator flashes until all the new
messages have been played.
To play all the messages, press PLAY/
SKIP . The TAD-1027 announces the
number of messages or if there are no
messages stored, the TAD announces,
“No message.”
Before playing each message, the TAD-
1027 announces the message number
and the day and time when the message
was recorded. After all messages play,
the TAD announces, “End of mes-
sage(s)” then it resets to answer calls.
Repeating Messages
To replay a message, if you have lis-
tened to at least 5 seconds of it, press
OGM/REPEAT. The current message
starts again.
If you have not listened to 5 seconds of
the message, or the message is not at
least 5 seconds long, pressing
OGM/RE-
PEAT replays the previous message.
Skipping Messages
To skip to the next message during play-
back, press
PLAY/SKIP once. The next
recorded message plays.
Pausing Message Playback
To pause message playback, press AN-
SWER/STOP/DELETE . To resume playing
messages, press PLAY/SKIP . Otherwise,
after pausing for 60 seconds, the TAD-
1027 sounds three beeps and stops
playback.
Stopping Message Playback
To stop playback at any time, press AN-
SWER/STOP/DELETE twice. The TAD-
1027 beeps once and resets to answer
calls.
DELETING MESSAGES
To delete all the messages you have al-
ready listened to, while playback is
stopped, hold down
ANSWER/STOP/DE-
LETE . The TAD-1027 sounds a long
beep then deletes all old messages, but
keeps any new messages (and the
PLAY/SKIP indicator continues flash-
ing).
Illus. showing PLAY/SKIP.
43-787.fm Page 11 Monday, August 16, 1999 8:11 AM