Ryobi BE321VS - Manual (Page 14)

14
OPERATION
TO ADJUST SANDING BELT TRACKING
See Figure 9.
n
Connect the sander to power supply.
n With sander positioned as shown below, pull switch trig-
ger and release immediately.
NOTE: This position is for adjustments only. Sanding belt
should not be in contact with workpiece or any foreign ob-
jects when making belt tracking adjustments.
n
Observe tracking of sanding belt. If the sanding belt runs
inward, slowly turn the tracking screw clockwise. If the
sanding belt runs outward, slowly turn the tracking screw
counterclockwise. This should be done until you are sure
belt will not run off sander, or come in contact with internal
parts.
NOTE: After installing a new sanding belt, it may become
necessary to change the adjustment several times until the
belt becomes conditioned.
CAUTION:
If the sanding belt wears excessively on the inner edge it
is probably adjusted too far inward and is rubbing against
internal parts. If this is the case, readjust the tracking
knob.
SANDING
BELT
TRACKING
SCREW
Fig. 9
TURN TRACKING SCREW TO ADJUST SANDING BELT
n When you are sure the belt will not rub against internal
parts, start the sander and fine adjust the tracking screw
until the belt stabilizes.
When correctly adjusted, the outer edge of the belt will
be even with the outer edge of the sander. Belt life will be
greatly increased if a few seconds are spent adjusting the
belt tracking.
NOTE: Replace a torn sanding belt immediately.
WARNING:
Keep hands and fingers away from moving sanding belt.
Any part of body coming in contact with moving sanding
belt could result in serious injury. Do not wear loose clothing
or jewelry when operating sander. They could get caught
in moving parts and foreign objects could get thrown from
sander causing injury.
TURN COUNTER-
CLOCKWISE IF BELT
RUNS INWARD
TURN CLOCKWISE IF
BELT RUNS OUTWARD