Operation – Ryobi BE321VS User Manual
Page 10
10
OPERATION
WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side
shields when operating power tools. Failure to do so
could result in objects being thrown into your eyes
resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
WARNING:
Before connecting the sander to a power supply, make
sure it is not in the locked-on position. Failure to do so
could result in accidental starting of the tool resulting in
serious injury.
APPLICATIONS
You may use this tool for the purposes listed below:
n
Sanding wood, metals, plastics, and other materials
n
Smoothing rough boards, chamfering, rounding edges
n
Removing rust, paint, varnishes, and stains
WARNING:
If your sanding job becomes particularly dusty or if
you have a breathing condition, wear a dust mask or
respirator to prevent damage to your health.
SELECTING SANDING BELTS
Selecting the correct size and type of sanding belt is an
important step in achieving a high quality sanded finish. Alu-
minum oxide, silicon carbide, and other synthetic abrasives
are best for power sanding.
In general, when sanding, coarse grit removes the most ma-
terial and fine grit produces the best finish. The condition of
the surface to be sanded determines which grit will do the
best job. If the surface is rough, start with a coarse grit and
sand until the surface is uniform. Then use medium grit to
remove scratches left by the coarser grit. Finally, use finer
grit for finishing the surface. Always continue sanding with
each grit until the surface is uniform.
SETTING THE BELT SANDER SPEED
Refer to the chart below for belt sander speed selections.
MATERIAL
SPEED
BELT GRIT
B
D
E
F
40
60
80
100
150
240
UNDRESSED TIMBER
SOFTWOOD
CHIPBOARD
VENEER TIMBER
RUST REMOVAL
PAINTED SURFACE
NON FERROUS METAL
C
A
« «
«
« «
« «
« «
« «
«